Remove And Replace A Drive - Cisco PC4000 Installation Manual

Remove and Replace a Drive

• Emergency shutdown—Press and hold the Power button for four seconds to force the main power off and immediately
enter standby mode.
Step 3
If a maintenance procedure instructs you to completely remove power from the Secure Endpoint PC4000, disconnect all
power cords from the power supplies.
Remove and Replace a Drive
Note
Note
Before you begin
Warning
Warning
Warning
Warning
Warning
Cisco Secure Endpoint PC4000 Hardware Installation Guide
36
The drives are hot-swappable. You do not have to shut down the PC4000 to remove or replace drives.
You cannot add more drives to your PC4000. You can only replace the drives in the slots that are supported
for your model.
This equipment must be grounded. To reduce the risk of electric shock, never defeat the ground conductor or
operate the equipment in the absence of a suitably installed ground conductor. Contact the appropriate electrical
inspection authority or an electrician if you are uncertain that suitable grounding is available.
There are no serviceable parts inside. To avoid risk of electric shock, do not open.
To reduce risk of electric shock or fire, installation of the equipment must comply with local and national
electrical codes.
Only a skilled person should be allowed to install, replace, or service this equipment. See statement 1089 for
the definition of a skilled person.
There are no serviceable parts inside. To avoid risk of electric shock, do not open.
Only an instructed person or skilled person should be allowed to install, replace, or service this equipment.
See statement 1089 for the definition of an instructed or skilled person.
There are no serviceable parts inside. To avoid risk of electric shock, do not open.
Maintenance and Upgrade