Replace (Remove And Install) Fan Tray - Cisco Catalyst 8300 Series Hardware Installation Manual

Install and Upgrade Field Replaceable Units
Note
SSD 2.5" Drives
Note
1. Remove the blank in the SSD slot
2. Install the drive into the slot and push forward until the drive seats in the connector
3. To secure the drives in the chassis, secure the screws on each side of the drive face
Figure 3: Installing the SSD 2.5" drives
1
2

Replace (Remove and Install) Fan Tray

1. Remove the top cover.
2. Remove the two screw that secure the fan tray in the chassis.
Keep the drive bays covered when there are no drives installed in the slot
The drive bays are in the front panel of the device. The bays are closed with a cover if there are no drives in
the slots.
Screws
SSD 2.5" Drives
Cisco Catalyst 8300 Series Edge uCPE Hardware Installation Guide
Replace (Remove and Install) Fan Tray
37