Connecting And Routing The Cables And Wires; Ntp-L36 Attaching Wires To Timing, Lan, And Craft Pin Connections In Ncs 2002 - Cisco NCS 2006 Hardware Installation Manual

Connecting and Routing the Cables and Wires

This chapter explains how to install the NCS 2002 shelf.
The sections are:
•
NTP-L36 Attaching Wires to Timing, LAN, and Craft Pin
Connections in NCS 2002
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Always use the supplied Electrostatic Discharge (ESD) wristband when working with a powered NCS
Caution
2002. For detailed instructions on how to wear the ESD wristband, refer to the
and Grounding Guide for Cisco NCS 2000 Series
NTP-L36 Attaching Wires to Timing, LAN, and Craft Pin Connections in NCS 2002, page 95
8
C H A P T E R
This procedure attaches wires to the Timing, LAN,
and Craft Pin connections in the NCS 2002 shelf.
Twisted #22 or #24 AWG (0.51 mm² or 0.64 mm²)
shielded wires for LAN or craft 75-ohm coaxial cable
with DIN 1.0/2.3 miniature coax connector.
NTP-L35 Installing the Power and Ground to the NCS
2002 Shelf, on page 76
As needed
Onsite
None
Electrostatic Discharge
Cisco NCS 2000 Series Hardware Installation Guide
95