Ntp-H115 Switch The Node Timing Reference; Ntp-H116 View The Timing Report - Cisco ONS 15310-MA SDH Procedure Manual

Chapter 14 Maintain the Node

NTP-H115 Switch the Node Timing Reference

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Complete the
Step 1
are already logged in, continue with Step 2.
As needed, use the following tasks to change the display of node timing maintenance information:
Step 2
•
•
Stop. You have completed this procedure.

NTP-H116 View the Timing Report

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Step 1 Complete the
timing status. If you are already logged in, continue with
Step 2 Click the Maintenance > Timing > Report tabs.
Step 3 In the Timing Report area you can view node timing information. The date and time of the report appear
at the top of the report. The time stamp is the same as the alarms time stamp and can be configured using
the
describes the report fields and entries.
To update the report, click Refresh.
Step 4
78-19416-01
"DLP-H29 Log into CTC" task on page 16-43
DLP-H177 Manual or Force Switch the Node Timing Reference, page 17-68
DLP-H178 Clear a Manual or Force Switched Node Timing Reference, page 17-68
"DLP-H29 Log into CTC" task on page 16-43
"DLP-H75 Display Alarms and Conditions Using Time Zone" task on page
This procedure switches the node timing reference to enable
maintenance on a timing reference or to return the node timing to normal
operation.
None
NTP-H23 Set Up Timing, page 3-10
As needed
Onsite or remote
Maintenance or higher
This procedure displays the current status of the ONS 15310-MA SDH
timing references.
None
NTP-H23 Set Up Timing, page 3-10
As needed
Onsite or remote
Retrieve or higher
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
at the node that you want to monitor. If you
at the node where you want to view the node
Step 2.
16-93.
Before You Begin
Table 14-2
14-15