Dlp-B310 View Ethernet Trunk Utilization; Ntp-B225 Switch The Node Timing Reference - Cisco ONS 15327 Procedure Manual

Chapter 14 Maintain the Node

DLP-B310 View Ethernet Trunk Utilization

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
In node view, click the Maintenance tab > Ether Bridge > Trunk Utilization tabs.
Step 1
Step 2 Select the desired time interval in the Interval field.
Click the Refresh button.
Step 3
The trunk utilization information for the current and previous time intervals is displayed.
Return to your originating procedure (NTP).
Step 4

NTP-B225 Switch the Node Timing Reference

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Complete the
Step 1
already logged in, continue with Step 2.
As needed, use the following tasks to change the display of Ethernet maintenance information:
Step 2
•
•
Stop. You have completed this procedure.
March 2003
"DLP-B 60 Log into CTC" task on page 2-23
"DLP-B 330 Manual or Force Switch the Node Timing Reference" task on page 14-28
"DLP-B 331 Clear a Manual or Force Switched Node Timing Reference" task on page 14-28
This task displays the Ethernet Trunk bandwidth usage on any node with
one or more E10/100-4 Ethernet cards installed.
None
DLP-B60 Log into CTC, page 2-23
As needed
Onsite ore remote
Retrieve or higher
This procedure switches the node timing reference to enable
maintenance on a timing reference or to return the node timing to normal
operation.
None
None
As needed
Onsite or remote
Maintenance or higher
NTP-B225 Switch the Node Timing Reference
at the node you want to monitor. If you are
Cisco ONS 15327 Procedure Guide, R4.0
14-27