Ntp-A8 Attach Wires To Alarm, Timing, Lan, And Craft Pin Connections, Page - Cisco ONS 15454 Install

NTP- A8 Attach Wires to Alarm, Timing, LAN, and Craft Pin Connections
Table 1-1
AEP Cable Wire
Black
White
Slate
Violet
Blue
Green
Yellow
Orange
Red
Brown
Continue with the
Step 6
procedure on page
Stop. You have completed this procedure.
NTP-A8 Attach Wires to Alarm, Timing, LAN, and Craft Pin
Connections
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
The covers are an integral part of the safety design of the product. Do not operate the unit without the
Warning
covers installed. Statement 1077
Complete the
Step 1
AIC-I card and are not using an AEP.
Complete the
Step 2
wires are necessary to provision external timing.
Complete the
Step 3
(or the LAN port on the TCC2/TCC2P) are necessary to create an external LAN connection.
Cisco ONS 15454 Procedure Guide, Release 8.5.1
1-16
Pin Assignments for the AEP
Backplane Pin AIC-I Signal
A1 GND
A2 AE_+5
A3 VBAT–
A4 VB+
A5 AE_CLK_P
A6 AE_CLK_N
A7 AE_DIN_P
A8 AE_DIN_N
A9 AE_DOUT_P
A10 AE_DOUT_N
"NTP-A8 Attach Wires to Alarm, Timing, LAN, and Craft Pin Connections"
1-16.
This procedure describes how to install alarm, timing, LAN, and craft
wires.
Wire wrapper
#22 or #24 AWG (0.51 mm² or 0.64 mm²) alarm wires
NTP-A4 Remove the Backplane Covers, page 1-7
As needed
Onsite
None
"DLP-A19 Install Alarm Wires on the Backplane" task on page 17-22
"DLP-A20 Install Timing Wires on the Backplane" task on page 17-27
"DLP-A21 Install LAN Wires on the Backplane" task on page 17-28
Chapter 1 Install the Shelf and Backplane Cable
AEP Signal
AEP_GND
AEP_+5
VBAT–
VB+
AE_CLK_P
AE_CLK_N
AE_DOUT_P
AE_DOUT_N
AE_DIN_P
AE_DIN_N
if you are using an
as needed. Timing
as needed. LAN wires
78-18537-01