Ntp-B188 Create An Automatically Routed Optical Circuit - Cisco ONS 15327 Procedure Manual

Chapter 5 Create Circuits and VT Tunnels
b.
c.
d.
Perform the protection switch test appropriate to the SONET topology:
Step 13
•
•
Step 14 Perform a bit error rate test (BERT) for 12 hours or follow your site requirements for length of time. For
information about configuring your test set for BERT, see your test set user guide.
After the BERT is complete, print the results or save them to a disk for future reference. For information
Step 15
about printing or saving test results see your test set user guide.
Stop. You have completed this procedure.

NTP-B188 Create an Automatically Routed Optical Circuit

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Complete the
Step 1
the circuit. If you are already logged in, continue with
If you want to assign a name to the tunnel source and destination ports before you create the circuit,
Step 2
complete the
From the View menu choose Go to Network View.
Step 3
Click the Circuits tab, then click Create.
Step 4
Step 5 In the Circuit Creation dialog box
•
•
•
•
March 2003
In the Set Circuit State dialog box, choose IS (in service), OOS (out of service) or OOS-AINS (auto
in service) from the Target State drop-down menu.
Check the Apply to drop ports check box.
Click Apply.
For path protection, complete the
For BLSRs complete the "DLP-B91 BLSR Ring Switch Test" task on page
This procedure creates an automatically-routed bidirectional or
unidirectional optical circuit, including STS-1 and concatenated STS-3c,
STS-6c, STS-9c, STS-12c, STS-24c, or STS-48c speeds.
None
NTP-B127 Verify Network Turn Up, page 5-3
As needed
Onsite or remote
Provisioning or higher
"DLP-B60 Log into CTC" task on page
"DLP-B314 Assign a Name to a Port" task on page
Name—Assign a name to the circuit. The name can be alphanumeric and up to 48 characters
(including spaces). Circuit names should be 44 characters or less if you want the ability to create
monitor circuits. If you leave the field blank, CTC assigns a default name to the circuit.
Type—Choose STS.
Size—Choose the optical circuit size: STS-1, STS-3c, STS-6c, STS-9c, STS-12c, STS-24c,
STS-48c.
Bidirectional—Leave checked for this circuit.
NTP-B188 Create an Automatically Routed Optical Circuit
"DLP-B94 Path Protection Switching Test" task on page 4-26
2-23at a node on the network where you will create
Step 2.
(Figure 5-10 on page 5-41), complete the following fields:
Cisco ONS 15327 Procedure Guide, R4.0
4-20.
5-16. If not, continue with Step 3.
5-39