Cautions And Regulatory Compliance Statements For Nebs; Power Supply Considerations; Power Connection Guidelines - Cisco 8011-2X2XP4L Hardware Installation Manual

Ple service endpoint router

Table of Contents

Safety Warnings

Cautions and Regulatory Compliance Statements for NEBS

The NEBS-GR-1089-CORE regulatory compliance statements and requirements are discussed in this section.

Warning

Check the power at your site to ensure that you are receiving clean power (free of spikes and noise). If

necessary, install a power conditioner.

This section provides guidelines for connecting the device power supplies to the site power source.

The intrabuilding port(s) of the equipment or subassembly, which is the management Ethernet port, must use

shielded intrabuilding cabling/wiring that is grounded at both ends. Statement 7003

The intrabuilding port(s) of the equipment or subassembly, which is the management Ethernet port, must not

be metallically connected to interfaces that connect to the OSP or its wiring. These interfaces are designed

for use as intrabuilding interfaces only (Type 2 or Type 4 ports as described in GR-1089-CORE) and require

isolation from the exposed OSP cabling. The addition of Primary Protectors is not sufficient protection in

order to connect these interfaces metallically to OSP wiring. Statement 7005

This equipment shall be connected to AC mains provided with a surge protective device (SPD) at the service

equipment complying with NFPA 70, the National Electrical Code (NEC). Statement 7012

This equipment is suitable for installations utilizing the Common Bonding Network (CBN). Statement 7013

This equipment is suitable for installation in Network Telecommunications Facilities. Statement 8015

This equipment is suitable for installation in locations where the NEC applies. Statement 8016

Hardware Installation Guide for Cisco 8011-2X2XP4L PLE Service Endpoint Router

Cautions and Regulatory Compliance Statements for NEBS

Table of Contents