Figure 1-4 Three-Shelf Ons 15454 Etsi (Ons 15454 Sdh) Bay Assembly - Cisco ONS 15454 Series Procedure Manual

Dwdm
Hide thumbs Also See for ONS 15454 Series:
Table of Contents

Advertisement

Required Tools and Equipment (ETSI)
Figure 1-4
Figure 1-4
4 ETSIs (SDH)
(ETSI only) Mount the air ramp above the ONS 15454 ETSI according to the
Step 3
Ramp" task on page
The air ramp is needed if you install more than one ONS 15454 ETSI shelf in a rack. To ensure that the
air ramp is secure, use one or two M6 mounting screws for each side of the shelf assembly.
shows how to mount an air ramp in the rack.
Cisco ONS 15454 DWDM Procedure Guide, Release 9.2
1-18
shows a three-shelf ONS 15454 ETSI bay assembly.
Three-Shelf ONS 15454 ETSI (ONS 15454 SDH) Bay Assembly
1-19.
Chapter 1
Install the Cisco ONS 15454 Shelf Assembly
Fuse and Alarm Panel,
mountable in the rack
if the rack is 2200 mm
(86.6 in.) high or higher
Air Ramp
Air Ramp
"DLP-G8 Install the Air
Figure 1-5
78-19286-01

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ons 15454Ons 15454 m2Ons 15454 m6

Table of Contents