Dlp-B51 Set Up A Windows Pc For Craft Connection To An Ons 15327 Using Dhcp - Cisco ONS 15327 Procedure Manual
Hide thumbs
Also See for ONS 15327:
- User documentation (559 pages) ,
- Manual (42 pages) ,
- Reference manual (166 pages)
Table of Contents
Advertisement
Chapter 2
Connect the PC and Log into the GUI
g.
h.
i.
Return to your originating procedure (NTP).
Step 6
DLP-B51 Set Up a Windows PC for Craft Connection to an ONS 15327 Using
DHCP
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Caution
You will not be able to connect to the ONS 15327 if DHCP forwarding is not enabled on the ONS 15327
or the ONS 15327 is not connected to a DHCP server. By default, DHCP forwarding is not enabled. If
you are connecting to an ONS 15327 to perform initial shelf turn up, complete the
Windows PC for Craft Connection to an ONS 15327 on the Same Subnet Using Static IP Addresses" task
on page 2-11
Automatic Host Detection" task on page
Verify the operating system that is installed on your computer:
Step 1
a.
b.
c.
Step 2
If you have Windows 95 or 98 installed on your PC, complete the following steps:
a.
b.
c.
d.
e.
f.
g.
h.
i.
March 2003
Click OK.
In the Local Area Connection Properties dialog box, click OK.
In the Local Area Connection Status dialog box, click Close.
This task sets up your computer for craft connection to the ONS 15327
using DHCP (dynamic host configuration protocol).
Straight-through (Category 5) LAN cable
NTP-B21 Set Up Computer for CTC, page 2-1
NTP-B169 Set Up CTC Network Access, page 3-7
As needed
Onsite
None
or the
"DLP-B52 Set Up a Windows PC for Craft Connection to an ONS 15327 Using
From the Windows Start menu, choose Settings > Control Panel.
In the Control Panel window, double-click the System icon.
In the General tab of the System Settings window, verify that the Windows operating system is one
of the following: Windows 95, Windows 98, Windows 2000, Windows NT 4.0, or Windows XP.
From the Windows Start menu, choose Settings > Control Panel.
In the Control Panel dialog box, click the Network icon.
In the Network dialog box, select TCP/IP for your PC Ethernet card, then click Properties.
In the TCP/IP Properties dialog box, click the DNS Configuration tab and choose Disable DNS.
Click the WINS Configuration tab and choose Disable WINS Resolution.
Click the IP Address tab.
In the IP Address window, click Obtain an IP address from a DHCP Server.
Click OK.
When the prompt to restart your PC appears, click Yes.
NTP-B22 Set Up CTC Computer to Connect to the ONS 15327
2-15.
Cisco ONS 15327 Procedure Guide, R4.0
"DLP-B50 Set Up a
2-13
Advertisement
Table of Contents
