Ntp-H162 Preprovision A Card Slot; Ntp-H163 Remove And Replace A Card - Cisco ONS 15310-MA SDH Procedure Manual

Chapter 1 Install the Cisco ONS 15310-MA SDH

NTP-H162 Preprovision a Card Slot

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Complete the
Step 1
the slot. If you are already logged in, continue with
Right-click the empty slot where you will later install a card.
Step 2
From the Add Card shortcut menu, navigate to Ethernet or En and choose the card type you want
Step 3
(CE-100T-8, CE-MR-6, or ML-100T-8 for Ethernet; E1_21_E3_DS3_3 or E1_63_E3_DS3_3 for En).
Note
Stop. You have completed this procedure.

NTP-H163 Remove and Replace a Card

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Blank faceplates and cover panels serve three important functions: they prevent exposure to
Warning
hazardous voltages and currents inside the chassis; they contain electromagnetic interference (EMI)
that might disrupt other equipment; and they direct the flow of cooling air through the chassis. Do not
operate the system unless all cards, faceplates, front covers, and rear covers are in place.
Statement 1029
If you are not logged into CTC and you need to remove a card, continue with
Step 1
CTC, troubleshoot the mismatched equipment (mismatchofEquipment) or Improper Removal
(IMPRMVL) alarm using the Cisco ONS 15310-MA SDH Troubleshooting Guide.
78-19416-01
This procedure describes how to preprovision a slot in the software before
physical card installation.
None
Chapter 2, "Connect the PC and Log into the GUI"
As needed
Onsite or remote
Provisioning or higher
"DLP-H29 Log into CTC" task on page 16-43
When you preprovision a slot, the card appears purple in the CTC shelf display. When you
physically install a card in the slot, the card appears white in the CTC shelf display.
This procedure describes how to remove and replace cards in the
ONS 15310-MA SDH shelf.
None
NTP-H154 Install the Ethernet Cards, page 1-19
NTP-H158 Install the Electrical Cables, page 1-27
As needed
Onsite
Provisioning or higher
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
Required Tools and Equipment
at the node where you want to preprosivion
Step 2.
Step 3. When you log into
1-33