Ntp-A4 Remove The Backplane Covers, Page; Ntp-A5 Install The Eias, Page; Procedure On Page - Cisco ONS 15454 Install

Chapter 1 Install the Shelf and Backplane Cable
NTP-A4 Remove the Backplane Covers
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Warning The covers are an integral part of the safety design of the product. Do not operate the unit without the
covers installed.
Complete the
Step 1
Step 2 Complete the
Step 3 If you plan to install electrical interface assemblies (EIAs), continue with the

procedure on page

page
Stop. You have completed this procedure.
78-18537-01
This procedure describes how to access the backplane by removing the
covers. The backplane has two sheet metal covers (one on either side)
and a lower backplane cover at the bottom.
#2 Phillips screwdriver
Medium slot-head screwdriver
Small slot-head screwdriver
NTP-A2 Install the Shelf Assembly, page 1-5
NTP-A3 Open and Remove the Front Door, page 1-6
Required
Onsite
None
"DLP-A10 Remove the Lower Backplane Cover" task on page
"DLP-A11 Remove the Backplane Sheet Metal Cover" task on page
1-8. If not, continue with the
1-9.
NTP- A4 Remove the Backplane Covers
"NTP-A6 Install the Power and Ground" procedure on
Cisco ONS 15454 Procedure Guide, Release 8.5.1
17-10.
17-11.
"NTP-A5 Install the EIAs"
1-7