Removal And Installation Of Instrument Panel - SSANGYONG Rexton Y200 Manual

9D-20 BODY ELECTRICAL
Brake
If the switch of starting turns on, the fluid of brake is
under specified level, or while lever of parking brake
is pulling, sensor of brake or switch of parking brake
is "on" and then warning of brake turns on.
Notice: Sensor of brake fluid is installed on the
reservoir tank of master cylinder.
1. Separate gauge connector of brake fluid level.
2. While switch is turned off, check applying of
electric current between terminal.
3. While switch is turned on, check applying of
YAD9D320
electric current between terminal.
Switch of parking brake
Switch of parking brake is located under lever of
parking brake, if switch of parking brake is adjusted,
after releasing parking brake, switch of parking brake
is installed .
1. While switch is turned on (lever is pulling), check
applying of electric current between terminal and
switch.
2. While switch is turned off (lever is released), check
applying of electric current between terminal and
switch, applying of electric current get out of
specification, replace switch, or check grounding.
YAD9D330
Door Switch
1. Switch of door is removed, check applying of
electric current between terminals.
2. If applying of electric current between terminals
get out of specification, replace switch of door.
YAD9D340
REMOVAL AND INSTALLATION OF
INSTRUMENT PANEL
1. Remove negative terminal of battery.
2. After releasing screw (2ea), remove housing of
instrument panel .
YAD9D350
SSANGYONG Y200