Check And Adjust - SSANGYONG Rexton Y200 Manual

9D-10 BODY ELECTRICAL

CHECK AND ADJUST

Adjust Focus of Head Lamp (Aiming)
Beam adjusting equipment approved can adjust
accurately focus of head lamp.
This equipment should be operated by manufacturer's
operation manual.
While focus of head lamp is arranged, condition of
vehicle keep air pressure of tire specified, except spare
tire and tool of OVM, every thing is unloaded, and
vehicle is parked on the even place.
If beam adjusting is not installed, focus of head lamp
can be arranged by using screen.
Using Beam Adjusting Equipment
1. Beam adjusting equipment should be arranged
with vehicle.
YAD9D140
2. Switch on control lever of up and down, left and
right by the screw, arrange focus of head lamp.
YAD9D150
Arrange Focus of Head Lamp by Screen (Unit: mm)
1. After screen (2 m x 1.5 m) installs the verticalness
position of 3m of distance from the front head lamp
of vehicle, keep line of center between vehicle and
screen such as the right below picture.
YAD9D160
SSANGYONG Y200