SSANGYONG Rexton Y200 Manual page 1574

9D-46 BODY ELECTRICAL
1. OFF Mode
If switch of wiper is turned off and switch of ignition
is turned on, at this time, rain sensor is operating
with OFF MODE, under this mode, wiper mode is
stopped, during rain sensor is OFF MODE, rain
sensor is sensing the state of windshield, so that
turn switch to proper position.
2. Auto Mode
If wiper switch is transferred OFF MODE into AUTO
MODE, immediately wiper is operating once, that
means wiper system is operating, after wiper is
operating once, is calcurated the time of gap
between drop of rain and speed of wiper operation.
After stoppng time, rain sensor transfer signal into
wiper motor, wipe out rain.
3. Automatic Intermittent Mode
At the automatic intermittent mode, wiper is
operating once with low speed, and then this mode
has variable stopping time.
4. Automatic Low Speed
This mode is operating beyond value of limit of
automatic intermittent and automatic low speed.
5. Automatic High Speed
As quantity of rain beyond value of automatic low
speed and automatic high speed is operating.
6. Washer Mode (48Page)
Rain sensor is sensing whether switch of wiper
select function of washer or not. If switch of wiper
is turned on more than 0.6 sec, wiper is operating
for 2.5 - 3.8sec, under this value is operating only
once. At washer mode, motor of wiper is operating
with low speed.
7. Manual Mode
Switch operation of driver turn motor of wiper to low
speed, high speed, at this time, wiper is operated
by not rain sensor by but wiper switch.
Notice: As rain sensor is out of order, wiper is
operating with low speed and high speed.
Characteristic of rain sensor
1.Supply power
Power is supplying to rain sensor and within 250
msec, rain sensor is emitting the signal " OFF" , until
effective power is supplying, effective power is
available for supplying power, after 2 second.
2. Speed of wiper and control frequency of
revolution
Main function of rain sensor is controlling wiper
speed and delaying of time to between the driving
time, due to sensing and the accumulation of rain,
algorithm of rain sensor is deciding mode of motion,
automatic intermittent, automatic low speed, and
automatic high speed.
If the stage is set, without the operation of driver,
wiper is continuously operating.
3. Transfer between the modes
Algorithm of rain sensor is transferred automatic
intermittent,automatic low speed, and automatic
high speed under low stage so doesn't make noise.
4. Performance of sensing
Sensing of rain sensor is set 5 stage, due to
accumulated drop of rain, driver can satisfy, range
of adjusting can control from the short delaying time
to thelong delaying time, but, due to heavy rain,
regardless of sensing which is set, is continuously
operating with high speed.
5. Responding characteristic of automatic low
speed
As wiper is operated from the zero state of
dropping of rain to the automatic low mode.
Time is needed within only 9 second for high
required signal.
6. Responding characteristic of automatic high
speed
As wiper is operated from the zero state of dropping
of rain to the automatic high mode.
Time is needed within only 9 second for high
required signal
7. Responding characteristic from the automatic
low speed to the automatic high speed
As wiper is operated from the automatic low speed
to the automatic high speed mode, time is needed
within only 6 second for high required signal.
8. Responding characteristic from the automatic
high speed to the state of off (48 Page)
As wiper is operated from the automatic high speed
mode to the the zero state of dropping of rain mode,
times of wiper motion is under 19 times.
9. The instant operating of wiper
While system of wiper is operating by switch of
wiper, before wiper back to the position of operating,
wiper is operating once, such as once operating, is
occurred at time from the lower stage to the high
stage by operating of wiper switch, but if the high
stage is moving to the low stage, once operating
of wiper does not happen.
SSANGYONG Y200