Toyota Tundra 2005 Service - Repair - Maintenance page 2099

LU−18
LUBRICATION (2UZ−FE)
(c)
6.
7.
(a)
(b)
(c)
B05838
(d)
Vinyl Tape
(e)
(f)
B05846
8.
(a)
New O−Ring
(b)
(c)
(d)
Push
(e)
9.
B05837
− OIL PUMP
S
Parts must be assembled within 3 minutes of ap-
plication. Otherwise the material must be removed
and reapplied.
S
Immediately remove nozzle from the tube and rein-
stall cap.
Install the No.2 oil pan with the 24 bolts and 2 nuts. Uni-
formly tighten the bolts and nuts in several passes.
Torque: 7.5 N·m (76 kgf·cm, 66 in.·lbf)
INSTALL CRANKSHAFT POSITION SENSOR
(See page IG−13)
INSTALL OIL FILTER, OIL COOLER AND FILTER
BRACKET ASSEMBLY
Install a new gasket to the oil filter bracket.
Install the oil filter, oil cooler and filter bracket assembly
with the 2 bolts and nut.
Torque: 18 N·m (185 kgf·cm, 13 ft·lbf)
Connect the oil cooler hose to the oil cooler.
Install the clamp.
Turn the clamp clockwise, and install the clamp to the oil
filter bracket.
Install the wire to the clamp with a vinyl tape.
Connect the oil pressure switch connector.
INSTALL OIL DIPSTICK GUIDE AND DIPSTICK
Install a new O−ring to the dipstick guide.
Apply soapy water to the O−ring.
Push in the oil dipstick guide end into the guide hole of the
No.1 oil pan.
Install the oil dipstick guide with the bolt.
Torque: 15 N·m, (155 kgf·cm, 11 ft·lbf)
Install the oil dipstick.
INSTALL CRANKSHAFT TIMING PULLEY
(See page EM−23)