Toyota Tundra 2005 Service - Repair - Maintenance page 2097

Hide thumbs Also See for Tundra 2005:

Table of Contents

LUBRICATION (2UZ−FE)

Use a 6 mm hexagon wrench for the hexagon head bolt.

Each bolt length is indicated in the illustration.

Bolt length:

35 mm (1.38 in.) for A of 12 mm head

50 mm (1.97 in.) for B of 12 mm head

106 mm (4.17 in.) for C of 12 mm head

40 mm (1.57 in.) for D of 14 mm head

30 mm (1.18 in.) for E of 6 mm hexagon head

INSTALL OIL STRAINER

Install a new gasket and the oil strainer with the 2 bolts and 2

Torque: 7.5 N·m (76 kgf·cm, 66 in.·lbf)

INSTALL NO.1 OIL PAN

Remove any old packing (FIPG) material and be careful

not to drop any oil on the contact surfaces of the No.1 oil

pan, cylinder block, oil pump and rear oil seal retainer.

Using a razor blade and gasket scraper, remove all

the old packing (FIPG) material from the gasket sur-

faces and sealing groove.

Thoroughly clean all components to remove all the

loose material.

Using a non−residue solvent, clean both sealing

Apply seal packing to the No.1 oil pan as shown in the il-

Seal packing: Part No. 08826−00080 or equivalent

Install a nozzle that has been cut to a 2 − 3 mm (0.08

− 0.12 in.) opening.

Parts must be assembled within 3 minutes of ap-

plication. Otherwise the material must be removed

and reapplied.

Immediately remove nozzle from the tube and rein-