Toyota Tundra 2005 Service - Repair - Maintenance page 2094

Cut Position
SST
LUBRICATION (2UZ−FE)
REPLACEMENT
REPLACE CRANKSHAFT FRONT OIL SEAL
HINT:
There are 2 methods ((a) and (b)) to replace the oil seal.
(a) If the oil pump is removed from the cylinder block:
(1)
A04865
(2)
SST
(3)
SST
A04866
(b) If the oil pump is installed to the cylinder block:
(1)
(2)
NOTICE:
Be careful not to damage the crankshaft. Tape the screw-
driver tip.
A04863
(3)
(4)
SST
A04864
− OIL PUMP
Using a screwdriver, pry out the oil seal.
Using SST and a hammer, tap in a new oil seal until
its surface is flush with the oil pump body edge.
09316−60011 (09316−00011)
Apply MP grease to the oil seal lip.
Using a knife, cut off the oil seal lip.
Using a screwdriver, pry out the oil seal.
Apply MP grease to a new oil seal lip.
Using SST and a hammer, tap in the oil seal until its
surface is flush with the oil pump body edge.
09316−60011 (09316−00011)
LU−13
LU0GX−05