Drive Mode Indicators - YASKAWA CIMR-F7Z44P0 User Manual

Drive Mode Indicators

The definition of the Drive mode indicators are shown in Table 3.2.
Indicator
FWD Lit when a forward run command is input and when Drive is in "Hand" Mode.
REV Lit when a reverse run command is input.
AUTO SEQ Lit when set up for remote run command. See Table 3.3
AUTO REF Lit when set up for remote speed command. See Table 3.4
ALARM Lit when a fault has occurred. Flashes when an alarm has occurred.
AUTO Sequence (SEQ) Indicator
The status of the AUTO "Sequence" (SEQ) indicator is shown in Table 3.3. This indicator is always "Off" when the Drive is in
the "Hand" mode. When the Drive is in the "Auto" mode, the SEQ indicator status is dependent on the setting of parameter
"b1-02" (Run Command Selection).
Indicator Status
On
Off
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Table 3.2 Drive Mode Indicators
Table 3.3 AUTO Sequence (SEQ) Indicator
Hand Mode
Parameter "b1-02" (Run Command Selection) is set to terminal strip,
communications, or an option board as indicated below:
b1-02=1 (Terminals)
=2 (Communications)
N/A
=3 (Option PCB)
Parameter "b1-02" (Run Command Selection) is set to digital operator
as indicated below:
b1-02=0 (Operator)
Digital Operator 3 - 5
Definition
Auto Mode