The Drive And Programming Modes - YASKAWA A1000 Series Quick Start Manual

4 Start-Up Programming & Operation
Menu Structure for Digital Operator
■
Figure 48
<1> Reverse can only be selected when the drive is set for LOCAL.

◆ The Drive and Programming Modes

The drive has a Programming Mode to program the drive for operation, and a Drive Mode used to actually run the motor.
Drive Mode: In the Drive Mode, the user can start the motor and observe operation status with the monitors that are
available. Parameter settings cannot be edited or changed when in the Drive Mode.
Programming Mode: The Programming Mode allows access to edit, adjust, and verify parameters, as well as perform
Auto-Tuning. Unless set to allow a Run command, the drive will not accept a Run command when the digital operator is
in the Programming Mode.
Changing Parameter Settings or Values
■
This example explains changing C1-02 (Deceleration Time 1) from 10.0 seconds (default) to 20.0 seconds.
1. Turn on the power to the drive. The initial display appears.
2.
Press the or
3.
Press the key to enter the parameter menu tree.
56
ALM
DIGITAL OPERATOR JVOP-182
DRV
REV DRV FOUT
Turn the power on
Reverse Selection
Forward Selection
Output Frequency
Output Current
Note: "XX" characters are shown in this manual.
Output Voltage The drive will display the actual setting values.
Monitor Display
X
X X
Verify Menu
X X
Set Up Mode
X X
Parameter Setting Mode
X X
X
Auto-Tuning
X
Figure 48 Digital Operator Menu and Screen Structure
Step
key until the Parameter Setting Mode screen appears.
YASKAWA ELECTRIC TOEP C710616 21C YASKAWA AC Drive - A1000 Quick Start Guide
Description of Key Operations
<1>
X X
X X X X
X X X X
X X X X
X
X X
X X
X X
X X X X
X X
X X
X X X X
X X
YEC_common
Display/Result
DIGITAL OPERATOR JVOP-182
DRV
REV DRV FOUT
ALM