Drive Mode Details; Setting The Frequency Reference While In Drive Mode - YASKAWA V1000 Series Installation & Start-Up Manual

4.3 The Drive and Programming Modes
Frequency Reference
Drive Mode

Drive Mode Details

■
The following actions are possible in the Drive Mode:
• Run and stop the drive.
• Monitor the operation status of the drive (frequency reference, output frequency, output
current, output voltage, etc.).
• View information on an alarm.
• View a history of alarms that have occurred.
Note: Select "Drive Mode" when running. The mode can be switched to any mode (program mode,
etc.) other than drive mode while the drive is stopped. However, the drive cannot be operated in
other modes. Return the mode to "Drive Mode" after completing periodic inspection.
Figure 4.4 illustrates changing the default frequency reference of F 0.00 (0 Hz) to F 6.00 (6
Hz) while in Drive Mode. This example assumes the drive is set to LOCAL.
Figure 4.4
Frequency reference
display at power up
STOP
Press until the frequency
reference becomes 6 Hz
Figure 4.4 Setting the Frequency Reference while in Drive Mode
Note: The drive will not accept a frequency reference set value unless the ENTER key is pressed after
the frequency reference is entered. This feature prevents accidental setting of the frequency
reference. By setting o2-05 (Frequency Reference Setting Method Selection) to 1 (Enabled), the
drive will accept the frequency reference while it is being adjusted on the digital operator.
100
Press to select LOCAL
YASKAWA ELECTRIC TOEP C710606 09B YASKAWA AC Drive V1000 Installation & Start-Up Manual
Returns to the frequency reference display screen.
Press to select the
digit to the right