Intel Cyclone 10 GX User Manual page 94

Refer to
2. Select GbE or GbE 1588 from the Transceiver configuration rules list located
under Datapath Options, depending on which protocol you are implementing.
3. Use the parameter values in the tables in
GbE and GbE with IEEE 1588v2
the protocol presets described in
GIGE-1.25 Gbps preset for GbE, and the GIGE-1.25 Gbps 1588 preset for GbE
1588. You can then modify the setting to meet your specific requirements.
4. Click Generate to generate the Native PHY IP core top-level RTL file.
Figure 41. Signals and Ports for Native PHY IP Configured for GbE or GbE with IEEE
1588v2
Generating the IP core creates signals and ports based on your parameter settings.
rx_is_lockedtodata
5. Instantiate and configure your PLL.
6. Instantiate a transceiver reset controller.
You can use your own reset controller or use the Native PHY Reset Controller IP
core.
7. Connect the Native PHY IP to the PLL IP and the reset controller. Use the
information in the figure below to connect the ports.
® ®
Intel Cyclone 10 GX Transceiver PHY User Guide
94
Select and Instantiate the PHY IP Core
tx_cal_busy
NIOS
rx_cal_busy Hard Calibration IP
TX PMA
tx_serial_data
Serializer
Local Clock
tx_serial_clk0
Generation
(from TX PLL)
Block
RX PMA
Deserializer
rx_serial_data
rx_cdr_refclk0
CDR
rx_is_lockedtoref
Note:
1. rx_rmfifostatus is not available in the GbE with 1588 configuration.
2. Implementing Protocols in Intel Cyclone 10 GX Transceivers
on page 17.
Native PHY IP Parameter Settings for
on page 95 as a starting point. Or, you can use
Transceiver Native PHY
Cyclone 10 Transceiver Native PHY
TX Standard PCS
10
unused_tx_parallel_data[118:0]
RX Standard PCS
10
unused_rx_parallel_data[111:0]
UG-20070 | 2018.09.24
Presets. Use the
reconfig_reset
Reconfiguration
reconfig_clk
Registers
reconfig_avmm
tx_digitalreset
tx_datak gmii_tx_ctrl
tx_parallel_data[7:0] gmii_tx_d[7:0]
tx_coreclkin gmii_tx_clk
tx_clkout tx_clkout
tx_analogreset
rx_analogreset
rx_digitalreset
rx_datak gmii_rx_ctrl
rx_parallel_data[7:0] gmii_rx_d[7:0]
rx_clkout gmii_rx_clk
rx_coreclkin
rx_errdetect rx_errdetect
rx_disperr rx_disperr
rx_runningdisp rx_runningdisp
rx_patterndetect rx_patterndetect
rx_syncstatus rx_syncstatus
rx_rmfifostatus rx_rmfifostatus (1)
Send Feedback