Intel Cyclone 10 GX User Manual page 188

2.10.1.1. How to Use NativeLink to Specify a ModelSim Simulation
Complete the following steps to specify the directory path and testbench settings for
your simulator:
1. On the Tools menu, click Options, and then click EDA Tool Options.
2. Browse to the directory for your simulator. The following table lists the directories
for supported simulators:
Simulator
Mentor Graphics ModelSim - Intel FPGA Edition
3. On the Assignments menu, click Settings.
4. In the Category list, under EDA Tool Settings select Simulation.
5. In the Tool name list, select your simulator.
Note: ModelSim refers to ModelSim SE and PE. These simulators use the same
commands as QuestaSim.ModelSim - Intel FPGA Edition refers to ModelSim - Intel
FPGA Edition Starter Edition and ModelSim - Intel FPGA Edition Subscription
Edition.
6. In the Output directory, browse to the directory for your output files.
7. To map illegal HDL characters, turn on Map illegal HDL characters.
8. To filter netlist glitches , turn on Enable glitch filtering.
9. Complete the following steps to specify additional options for NativeLink
automation:
a. Turn on Compile test bench.
b. Click Test Benches.
The Test Benches dialog box appears.
c. Click New.
d. Under Create new test bench settings, for Test bench name type the test
bench name. For Top level module in the test bench, type the top-level module
name. These names should match the actual test bench module names.
e. Select Use test bench to perform VHDL timing simulation and specify the
name of your design instance under Design instance name in test bench.
f. Under the Simulation period, turn on Run simulation until all vector
stimuli are used.
g. Under Test bench and simulation files, select your test bench file from your
folder. Click Add.
h. Click OK.
® ®
Intel Cyclone 10 GX Transceiver PHY User Guide
188
2. Implementing Protocols in Intel Cyclone 10 GX Transceivers
Directory
<drive>:\<simulator install path>\win32aloem
(Windows)
/<simulator install path>/bin (Linux)
UG-20070 | 2018.09.24
Send Feedback