Speed (Management Interface) - Dell S6000 Reference Manual

Usage
The shutdown command marks a physical interface as unavailable for traffic. To
Information
discover if an interface is disabled, use the show ip interface brief
command. Disabled interfaces are listed as down.
Disabling a VLAN or a port channel causes different behavior. When a VLAN is
disabled, the Layer 3 functions within that VLAN are disabled. Layer 2 traffic
continues to flow. Entering the shutdown command on a port channel disables all
traffic on the port channel and the individual interfaces within the port channel. To
enable a port channel, enter no shutdown on the port channel interface and at
least one interface within that port channel.
The shutdown and description commands are the only commands that you
can configure on an interface that is a member of a port channel.
Related
interface port-channel
Commands
interface vlan
show ip interface
to display a table of interfaces and their status.

speed (Management interface)

Set the speed for the Management interface.
S6000
Syntax
speed {10 | 100 | 1000 | auto}
To return to the default setting, use the no speed command.
Parameters
10
100
1000
auto
Defaults auto
Command INTERFACE
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Interfaces
— creates a port channel interface.
— creates a VLAN.
— displays the interface routing status. Add the keyword brief
Enter the keyword 10 to set the interface's speed to 10 Mb/s.
Enter the keyword 100 to set the interface's speed to 10/100
Mb/s.
Enter the keyword 1000 to set the interface to auto-
negotiate its speed.
Enter the keyword auto to set the interface to auto-
negotiate its speed.
685