SROS Command Line Interface Reference Guide
ip rip receive version [1 | 2]
Use the ip rip receive version command to configure the RIP version the unit accepts in all RIP packets
received on the interface. Use the no form of this command to restore the default value.
Syntax Description
1
2
Default Values
By default, all interfaces implement RIP version 1 (the default value for the version command).
Functional Notes
Use the ip rip receive version to specify a RIP version that overrides the version (in the Router RIP)
configuration.
The SROS only accepts one version (either 1 or 2) on a given interface.
Usage Examples
The following example configures the virtual PPP interface to accept only RIP version 2 packets:
ProCurve(config)#interface ppp 1
ProCurve(config-ppp 1)#ip rip receive version 2
5991-2114
Accepts only received RIP version 1 packets on the interface.
Accepts only received RIP version 2 packets on the interface.
© Copyright 2007 Hewlett-Packard Development Company, L.P.
PPP Interface Configuration Command Set
1118
Need help?
Do you have a question about the ProCurve 7102dl and is the answer not in the manual?