Fujitsu MB96300 series Hardware Manual page 225

MB96300 Super Series Hardware Manual
address 00040B
another reset is generated (a setting of "1" is retained).
After a Power reset, the register should be cleared by reading in order to initialize all bits.
Note:
If the power is turned on under conditions where power-on reset may not occur (power-on profile as
specified in the datasheet not met), the value in RCCSR register is not guaranteed.
■ Notes about clock missing flags
For details about the clock missing flags MCMF and SCMF refer to section 8.6 "Operation of the Clock stop
detection function and reset".
. Any bit corresponding to a reset cause that has already been generated is not cleared when
H
CHAPTER 8 RESETS AND STARTUP
217