Table of Contents
Advertisement
MB96300 Super Series Hardware Manual
[bit7-bit0]
MSGN
0x00
0x01-0x80
0x81-0xFF
Note:
The Busy Flag can only be used in BASIC mode (see "Basic Mode" on page 578). When using the
Message RAM (BASIC=0) the hardware interface controls the access for read and write and this flag is
always read as '0'.
Note:
When a Message Number that is not valid is written into the Command Request Register, the Message
Number will be transformed into a valid value and that Message Object will be transferred.
Message Number (for 128 message buffer CANs, please refer to the data sheet for the number of message buffers
Not a valid Message Number, interpreted as 0x80.
Valid Message Number, the Message Object in the Message RAM is selected for data transfer.
Not a valid Message Number, interpreted as 0x01-0x7F.
CHAPTER 22 CAN CONTROLLER
of the device.)
599
Advertisement
Table of Contents
