MB96300 Super Series Hardware Manual CHAPTER 9 STANDBY MODE AND VOLTAGE REGULATOR CONTROL
Note:
The different Timer modes may have the same behavior if more than one of the PCE, MCE, SCE and
RCE bits is set to "1". However, the run mode that the device transits to, upon wakeup from timer mode
by interrupt, depends on which of the four timer modes the device was in. Refer to Table 9.5-1 "Mode
change table".
■ Stop Mode
In this mode, the standby control circuit causes all oscillations to stop. All functions are inactivated.
Note:
Because the Stop mode turns all oscillation clocks off, data can be retained by the lowest power
consumption.
233