Example Of Connecting A Programming Tool For Programming The Flash Microcontroller - Fujitsu MB96300 series Hardware Manual

CHAPTER 36 EXAMPLES OF SERIAL PROGRAMMING CONNECTIONMB96300 Super Series Hardware Manual
36.3 Example of connecting a programming tool for
programming the Flash Microcontroller
Figure 36.3-1 is an example of connecting a programming tool to program the flash
microcontroller.
■ Example of connecting a programming tool to program the flash microcontroller
For high speed programming a device programmer must be connected as shown in the example below. Please
refer to the datasheet for an overview of USART channels available for flash serial programming.
Please refer to the datasheet to determine the port used for handshaking between the device programmer and
the MCU.
Figure 36.3-1 Example of a connection to a device programmer to program the flash microcontroller which
Device Programmer
Connector
908
is started in internal vector mode in the application.
In application, device
starts in internal vector
mode.
This diode is only
needed when the
device programmer
supply is used.
User power
supply
MB96300 Super series Flash MCU
SOTn
SINn
SCKn
Pnn_m
RSTX
X0
X1
C
MD0
MD1
MD2
Vcc
Vss