Table of Contents
Advertisement
MB96300 Super Series Hardware Manual
Note:
• The A/D conversion in the continuous or stop mode continues until it is stopped by the BUSY bit.
• Write 0 to the BUSY bit to stop the A/D conversion.
• Reactivation is disabled in single mode2, continuous mode, and stop mode. This applies to all kinds of
activation.
[bit 5] S10
This bit specifies the resolution of conversion. When "0" is written to this bit, 10-bit A/D conversion is
performed. When "1" is written to this bit, 8-bit A/D conversion is performed and the conversion result is
stored in D7 to D0.
[bits 4 to bit 1] Unused bits
Writing to these bits has no effect. Reading these bits always returns "1".
[bit 0] reserved (reserved bit)
This bit is a reserved bit. Always write "0" to this bit.
Reading this bit always returns "0".
CHAPTER 18 A/D CONVERTER
441
Advertisement
Table of Contents
