Delta ASDA-A2 Series User Manual page 493

Chapter 8 Servo Parameters
Please note:
ASDA-A2 series L type models do not provide Electronic Cam (E-Cam) function.
P5-90 CMAP E-Cam: Area Number + (Polarity is Positive)
Operation
Interface:
Default: 0
Control
Mode:
Range: 0 ~ 360
Data Size: 16-bit
Display
Format:
Settings:
This parameter is used to set the start degree of digital output, CAM_AREA (DO code
is 0x18) when Electronic Cam (E-Cam) is engaged.
Please note:
ASDA-A2 series L type models do not provide Electronic Cam (E-Cam) function.
P5-91 CMAN E-Cam: Area Number - (Polarity is Negative)
Operation
Interface:
Default: 0
Control
Mode:
Range: 0 ~ 360
Data Size: 16-bit
Display
Format:
Settings:
This parameter is used to set the end degree of digital output, CAM_AREA (DO code
is 0x18) when Electronic Cam (E-Cam) is engaged.
Please note:
ASDA-A2 series L type models do not provide Electronic Cam (E-Cam) function.
8-216
Keypad / Software
PR
Unit: degree (it becomes degree in firmware
version V1.009 and later models)
Decimal
Keypad / Software
PR
Unit: degree (it becomes degree in firmware
version V1.009 and later models)
Decimal
Communication
Communication
ASDA-
Address: 05B4H
05B5H
Related Section:
Section 7.11
Address: 05B6H
05B7H
Related Section:
Section 7.11
Revision September 2012
A2