Delta ASDA-A2 Series User Manual page 285

Chapter 8 Servo Parameters
Parameter Name
P1-75 FELP
P1-76 AMSPD
Explanation of symbols (marked after parameter)
( ★ ) Read-only register.
( ▲ ) Parameter cannot be set when Servo On (when the servo drive is enabled).
(  ) Parameter is effective only after the servo drive is restarted (after switching power off
and on).
(  ) Parameter setting values are not retained when power is off.
8-8
Basic Parameters
Function
Full-closed Loop Low-pass Filter
Time Constant
Max. Rotation Speed of Encoder
Output
Control
Default Unit
PT PR S T
100 ms
 
5500 r/min    
Revision September 2012
A2
ASDA-
Mode