Delta ASDA-A2 Series User Manual page 312

A2
ASDA-
129: Error occurs when writing CANopen PDO object into EE-PROM.
130: EE-PROM invalid address range
131: EE-PROM checksum error
132: Password error
Motion Control Fault Codes:
201: CANopen data initial error
213: Write parameter error: exceeds the limit of normal range
215: Write parameter error: read only
217: Write parameter error: parameter lock
219: Write parameter error: parameter lock
235: PR command overflow
245: PR positioning time out
249: Invalid PR path number
261: Index error occurs when accessing CANopen object.
263: Sub-index error occurs when accessing CANopen object.
265: Data type (size) error occurs when accessing CANopen object.
267: Data range error occurs when accessing CANopen object.
269: CANopen object is read-only and write-protected.
26b: CANopen object does not support PDO.
26d: CANopen object is write-protected when Servo On.
26F: Error occurs when reading CANopen object from EE-PROM.
271: Error occurs when writing CANopen object into EE-PROM.
273: EE-PROM invalid address range
275: EE-PROM checksum error
277: Password error
283: Forward software limit
285: Reverse software limit
289: Position counter overflow
291: Servo Off error
301: CANopen SYNC failed
302: CANopen SYNC signal error
303: CANopen SYNC time out
304: CANopen IP command failed
305: SYNC period error
380: Position deviation alarm for digital output, MC_OK (Please refer to P1-48.)
Absolute System Fault Messages
028: Voltage level above specification
029: Gray code error
060: Absolute position lost
Revision September 2012
Chapter 8 Servo Parameters
8-35