Delta ASDA-A2 Series User Manual page 456

A2
ASDA-
Settings:
This parameter is used to read the data block 0 of data arrady (Array[P5-11++]).
For example, when P5-11 is set to 100, the first read data displayed by P5-12 is
the 100th data, the secondary read data is 101+1=102th data, the third read
data is 102+1 = 103th data and vise versa. By the same logic, when P5-11 is set
to 100, the first written data displayed by P5-12 is the 100th data, the secondary
written data is 101+1=102th data, the third written data is 102+1 = 103th data
and vise versa. However, if P5-12 is read via the drive keypad, only the 101th
data will be read.
P5-13 AYD1
Operation
Interface:
Default: 0
Control
Mode:
Range: -2147483648 ~ +2147483647
Data Size: 32-bit
Display
Format:
Settings:
This parameter is used to read the data block 2 of data arrady (Array[P5-11++]).
The usage of this parameter is the same as the parameter P5-12. Only one
function is different. When P5-12 is read via the drive keypad, the first read data
displayed by P5-12 is the 100th data, the secondary read data is 101+1=102th
data, the third read data is 102+1 = 103th data and vise versa. It indicates that
using P5-13 can read more than one data via the drive keypad. Please note that
using P5-13 can not write data via the drive keypad.
P5-14 Reserved (Do Not Use)
P5-15 PMEM PATH 1 ~ PATH 2 Data Not Retained Setting
Operation
Interface:
Default: 0x0
Control
Mode:
Range: 0x0 ~ 0x0011
Data Size: 16-bit
Display
Format:
Revision September 2012
Data Array: Read / Write Data Block 2
Keypad / Software
ALL
Unit: N/A
Decimal
Keypad / Software
ALL
Unit: N/A
Hexadecimal
Chapter 8 Servo Parameters
Communication
Communication
Address: 051AH
051BH
Related Section:
Section 7.2
Address: 051CH
051DH
Address: 051EH
051FH
Related Section: N/A
8-179