Show Interfaces Tunnel; Tunnel Destination - Dell PowerConnect 8024 Cli Reference Manual

show interfaces tunnel

Use the show interfaces tunnel command in Privileged EXEC mode to display the parameters
related to tunnel such as tunnel mode, tunnel source address and tunnel destination address.
Syntax
show interfaces tunnel [
tunnel-id — Tunnel identifier. (Range: 0–7)
•
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode.
User Guidelines
This command has no user guidelines.
Examples
The following examples show the parameters related to an individual tunnel and to all tunnel
interfaces.
console#show interfaces tunnel 1
Interface Link Status.......................... down
MTU size....................................... 1480 bytes
console#show interfaces tunnel
TunnelId
--------
1
2

tunnel destination

Use the tunnel destination command in Interface Configuration mode to specify the
destination transport address of the tunnel.
Syntax
tunnel destination
860
Tunnel Interface Commands
tunnel-id
]
Interface TunnelMode
--------- ----------
tunnel 1 IPv6OVER4
tunnel 2 IPv6OVER4
ipv4addr
SourceAddress DestinationAddress
------------- ----------------
10.254.25.14 10.254.25.10
10.254.20.10