Mapping C-Tag To S-Tag Dot1P Values; Layer 2 Protocol Tunneling - Dell S6000–ON Configuration Manual

Hide thumbs Also See for S6000–ON:

Table of Contents

Mapping C-Tag to S-Tag dot1p Values

To map C-Tag dot1p values to S-Tag dot1p values and mark the frames accordingly, use the following

Allocate CAM space to enable queuing frames according to the C-Tag or the S-Tag.

CONFIGURATION mode

cam-acl l2acl number ipv4acl number ipv6acl number ipv4qos number l2qos

number l2pt number ipmacacl number ecfmacl number {vman-qos | vman-qos-dual-

vman-qos: mark the S-Tag dot1p and queue the frame according to the original C-Tag dot1p.

This method requires half as many CAM entries as vman-qos-dual-fp.

vman-qos-dual-fp: mark the S-Tag dot1p and queue the frame according to the S-Tag dot1p.

This method requires twice as many CAM entries as vman-qos and FP blocks in multiples of 2.

The default is: 0 FP blocks for vman-qos and vman-qos-dual-fp.

The new CAM configuration is stored in NVRAM and takes effect only after a save and reload.

EXEC Privilege mode

copy running-config startup-config

Reload the system.

Map C-Tag dot1p values to a S-Tag dot1p value.

INTERFACE mode

vlan-stack dot1p-mapping c-tag-dot1p values sp-tag-dot1p value

Separate C-Tag values by commas. Dashed ranges are permitted.

Dynamic Mode CoS overrides any Layer 2 QoS configuration in case of conflicts.

NOTE: Because dot1p-mapping marks and queues packets, the only remaining applicable QoS

configuration is rate metering. You may use Rate Shaping or Rate Policing.

Spanning tree bridge protocol data units (BPDUs) use a reserved destination MAC address called the

bridge group address, which is 01-80-C2-00-00-00.

Only spanning-tree bridges on the local area network (LAN) recognize this address and process the

BPDU. When you use VLAN stacking to connect physically separate regions of a network, BPDUs

attempting to traverse the intermediate network might be consumed and later dropped because the

intermediate network itself might be using spanning tree (shown in the following illustration).

Service Provider Bridging