Link Aggregation Control Protocol (LACP)
This chapter contains commands for Dell Networks's implementation of the link aggregation control
protocol (LACP) for creating dynamic link aggregation groups (LAGs) — known as "port-channels" in the
Dell Networking operating software. The LACP commands in this chapter are supported by Dell
Networking OS on the S6000 platform.
NOTE: For static LAG commands, refer to
based on the standards specified in the IEEE 802.3 Carrier sense multiple access with collision
detection (CSMA/CD) access method and physical layer specifications.
clear lacp counters
Clear port channel counters.
S6000
Syntax
clear lacp port-channel-number counters
Parameters
port-channel-
number
Defaults
Without a Port Channel specified, the command clears all Port Channel counters.
Command
•
Modes
•
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 7.6.1.0
Version 7.5.1.0
856
Port Channel Commands
Enter a port-channel number. The range is from 1 to 128.
EXEC
EXEC Privilege
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
in the
Interfaces
chapter),
Link Aggregation Control Protocol (LACP)
27