Show Cam-Acl - Dell Force10 Z9000 Reference Manual

Defaults cam-profile default microcode default
Command Modes CONFIGURATION
Command History
Version 8.2.1.0
Version 7.9.1.0
Version 7.5.1.0
Version 7.4.2.0
Version 7.4.1.0
Version 6.5.1.0
Version 6.3.1.0
Usage You must save the running configuration using the copy running-config startup-
Information
config command after changing the CAM profile from CONFIGURATION mode. CAM profile
changes take effect after the next chassis reboot.

show cam-acl

Display the details of the CAM profiles on the chassis and all line cards.
C-Series, Z-SEries, S4810
Syntax show cam-acl
Defaults none
Command Modes EXEC Privilege
•
•
•
•
Added support for the ipv4-64k-ipv6 profile.
Added support for the VRF protocols.
Added the l2-ipv4-inacl CAM profile.
Added the unified-default CAM profile and lag-hash-
align microcode.
Added the lag-hash-mpls microcode.
Added the eg-default and ipv4-320k CAM profiles.
Introduced on the E-Series.
NOTE: Do not use the ipv4-egacl-16 CAM profile for Layer 2 egress ACLs.
NOTE: Do not make any changes to the CAM profile after you change the profile to
ipv4-320K and save the configuration until after you reload the chassis; any changes
lead to unexpected behavior. After you reload the chassis, you may make changes to the
IPv4 Flow partition.
Enter the keywords acl-group to select the microcode for
applications that need 16k egress IPv4 ACLs.
Enter the keywords ipv4-vrf to select the microcode for
IPv4 VRF applications.
Enter the keywords ipv4-v6-vrf to select the microcode
for IPv4 and IPv6 VRF applications.
E-Series TeraScale only: Select l2-switched-pbr
microcode if you apply a PBR redirect list to a VLAN interface
and want to prevent Layer 2 traffic from being redirected and
dropped. l2-switched-pbr (IPv4-LDA) microcode allows
only Layer 3 traffic to be redirected while Layer 2 traffic is
switched within the VLAN.
551