Send - Dell Force10 Z9000 Reference Manual

Usage The LED setting is not saved through power cycles.
Information

send

Send messages to one or all terminal line users.
C-Series, E-Series, S-Series, Z-Series
Syntax send [*] | [line ] | [aux] | [console] | [vty]
Parameters
*
line
aux
console
vty
Defaults none
Command Modes EXEC
Command History
Version 8.3.11.1
Version 8.1.1.0
Version 7.6.1.0
Version 7.5.1.0
Version 6.5.1.0
Usage Messages can contain an unlimited number of lines; however, each line is limited to 255
Information characters. To move to the next line, use the <CR>. To send the message use CTR-Z;to abort
a message use CTR-C.
Enter the asterisk character * to send a message to all tty lines.
Send a message to a specific line. Range: 0 to 11.
Enter the keyword aux to send a message to an auxiliary line.
NOTE: This option is supported on the E-Series only.
Enter the keyword console to send a message to the primary
terminal line.
Enter the keyword vty to send a message to the virtual terminal.
Introduced on the Z9000.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
133