Dell Force10 Z9000 Reference Manual page 965

Parameters
interface
detail
Defaults none
Command Modes EXEC Privilege
Command History
Version 9.1.(0.0)
Version 8.3.11.1
Version 8.5.1.0
Version 8.3.7.0
Version 7.7.1.0
Version 7.6.1.0
Version 7.4.1.0
Usage Omitting the keyword detail displays only the remote chassis ID, Port ID, and Dead Interval.
Information
Example
R1(conf-if-gi-1/31)#do show lldp neighbors
Loc PortID Rem
--------------------------------------------------------------
Gi 1/21
Gi 1/31
(OPTIONAL) Enter the following keywords and slot/port or number
information:
• For a Fast Ethernet interface, enter the keyword
FastEthernet followed by the slot/ port information.
• For a 1-Gigabit Ethernet interface, enter the keyword
gigabitEthernet followed by the slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
tenGigabitEthernet followed by the slot/port
information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by the slot/port information.
(OPTIONAL) Enter the keyword detail to display all the TLV
information, remote management IP addresses, timers, and LLDP tx
and rx counters.
Modified output of detail parameter to display remote management IP
addresses.
Introduced on the Z9000.
Added support for 4-port 40G line cards on ExaScale.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
Host Name
R2 GigabitEthernet
R3 GigabitEthernet
Rem Port Id Rem Chassis Id
2/11 00:01:e8:06:95:3e
3/11 00:01:e8:09:c2:4a
965