Neighbor Route-Map - Dell Force10 Z9000 Reference Manual

Version 7.7.1.0
Usage
Applies to EBGP neighbors only.
Information
You must configure your system to accept 4-byte formats before entering a 4-byte AS Number.
If the AS-PATH contains both public and private AS number or contains AS numbers of an
EBGP neighbor, the private AS numbers are not removed.
If a confederation contains private AS numbers in its AS-PATH, the software removes the
private AS numbers only if they follow the confederation numbers in the AS path.
Private AS numbers are 64512 to 65535 (2-byte).

neighbor route-map

Apply an established route map to either incoming or outbound routes of a BGP neighbor or peer group.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax neighbor {ip-address | peer-group-name} route-map map-name {in
| out}
To remove the route map, use the no neighbor {ip-address | peer-group-
name} route-map map-name {in | out} command.
Parameters
ip-address
peer-group-name
map-name
in
out
Defaults Not configured.
Command Modes ROUTER BGP
Command History
Version 8.3.11.1
Version 8.3.7.0
Version 7.8.1.0
Version 7.7.1.0
Usage
When you apply a route map to outbound routes, only routes that match at least one section of
Information
the route map are permitted.
If you identify a peer group by name, the peers in that peer group inherit the characteristics in
the Route map used in this command. If you identify a peer by IP address, the Route map
overwrites either the inbound or outbound policies on that peer.
374
Introduced on the C-Series. Added 4-byte support.
Enter the IP address of the neighbor in dotted decimal format.
Enter the name of the peer group.
Enter the name of an established route map.
If the Route map is not configured, the default is deny (to drop all
routes).
Enter the keyword in to filter inbound routes.
Enter the keyword out to filter outbound routes.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.