Dell Force10 Z9000 Reference Manual page 843

ipv6-address
distance
tag
permanent
Defaults none
Command Modes CONFIGURATION
Command History
Version 9.0.0.0
Version 8.3.7.0
Version 8.5.1.0
Version 8.2.1.0
Version 7.8.1.0
Version 7.4.1.0
•
•
•
•
•
If you configure a static IPv6 route using an egress interface and
enter the ping command to reach the destination IPv6 address, the
ping operation may not work. Configure the IPv6 route using a next-
hop IPv6 address in order for the ping command to detect the
destination address.
(OPTIONAL) Enter the forwarding router IPv6 address in the x:x:x:x::x
format.
NOTE: The :: notation specifies successive hexadecimal fields of
zeros.
(OPTIONAL) Enter a number as the metric distance assigned to the
route. The range is 1 to 255.
value
(OPTIONAL) Enter the keyword tag followed by a tag value number.
The range is 1 to 4294967295.
(OPTIONAL) Enter the keyword permanent to specify that the route
is not to be removed, even if the interface assigned to that route goes
down.
NOTE: If you disable the interface with an IPv6 address
associated with the keyword permanent, the route disappears
from the routing table.
Introduced on the Z9000.
Introduced on the S4810.
Added support for 4-port 40G line cards on ExaScale.
Introduced on the E-Series ExaScale.
Introduced on the C-Series and S-Series.
Introduced on the E-Series TeraScale.
For the null interface, enter the keyword null followed by
zero (0).
For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port
information.
For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by the slot/port information.
For a VLAN interface, enter the keyword VLAN followed by
the vlan number.
For a port channel interface, enter the keyword port-
channel followed by the port channel number.
843