Show Config - Dell Force10 Z9000 Reference Manual

Command History
Version 8.3.12.0
Version 7.8.1.0
Version 6.3.1.0
Usage Set the overload bit when a router experiences problems, such as a memory shortage due to
Information an incomplete link state database which can result in an incomplete or inaccurate routing
table. If you set the overload bit in its LSPs, other routers ignore the unreliable router in their
SPF calculations until the router has recovered.

show config

Display the changes you made to the IS-IS configuration. Default values are not shown.
E-Series, S4810
Syntax show config
Command Modes
Example (Router-
The bold section identifies that Multi-Topology IS-IS is enabled in Transition mode.
Isis)
FTOS(conf-router_isis)#show config
!
router isis
clns host ISIS 49.0000.0001.F100.E120.0013.00
log-adjacency-changes
net 49.0000.0001.F100.E120.0013.00
!
address-family ipv6 unicast
maximum-paths 16
multi-topology transition
set-overload-bit
spf-interval level-1 100 15 20
spf-interval level-2 120 20 25
exit-address-family
Example
The bold section identifies that Multi-Topology IS-IS is enabled in Transition mode.
(Address-
FTOS(conf-router_isis-af_ipv6)#show conf
Family_IPv6)
!
address-family ipv6 unicast
maximum-paths 16
multi-topology transition
set-overload-bit
spf-interval level-1 100 15 20
spf-interval level-2 120 20 25
exit-address-family
• CONFIGURATION-ROUTER-ISIS-ADDRESS-FAMILY-IPV6 (
Introduced on the S4810.
Added support for multi-topology ISIS.
Introduced.
for IPv4 )
• ROUTER ISIS (
• CONFIGURATION-ROUTER-ISIS-ADDRESS-FAMILY-IPV6 (
for IPv6 )
for IPv6 )
895