Hello; Mode - Dell Force10 Z9000 Reference Manual

hello

Configure the rate at which the LLDP control packets are sent to its peer.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax hello seconds
To revert to the default, use the no hello seconds command.
Parameters
seconds
Defaults 30 seconds
Command Modes CONFIGURATION (conf-lldp) and INTERFACE (conf-if-
Command History
Version 8.3.11.1
Version 8.3.7.0
Version 7.7.1.0
Version 7.6.1.0
Version 7.4.1.0

mode

Set LLDP to receive or transmit.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax mode {tx | rx}
To return to the default, use the no mode {tx | rx} command.
Parameters
tx
rx
Defaults Both transmit and receive.
Command Modes CONFIGURATION (conf-lldp) and INTERFACE (conf-if-
Command History
Version 8.3.11.1
Version 8.3.7.0
Version 7.7.1.0
962
Enter the rate, in seconds, at which the control packets are sent to its
peer. The rate is 5 to 180 seconds. The default is 30 seconds.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
Enter the keyword tx to set the mode to transmit.
Enter the keyword rx to set the mode to receive.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
interface -lldp)
interface -lldp)