Neighbor Shutdown; Neighbor Subnet - Dell Force10 Z9000 Reference Manual

Usage
The first time you enter this command it configures the neighbor as a route reflector and
Information
members of the route-reflector cluster. Internal BGP (IBGP) speakers do not need to be fully
meshed if you configure a route reflector.
When all clients of a route reflector are disabled, the neighbor is no longer a route reflector.

neighbor shutdown

Disable a BGP neighbor or peer group.
C-Series, E-Series
Syntax neighbor {ipv6-address | peer-group-name} shutdown
To enable a disabled neighbor or peer group, use the no neighbor {ipv6-address |
peer-group-name} shutdown command.
Parameters
ipv6-address
peer-group-name
Defaults Enabled (that is, BGP neighbors and peer groups are disabled.)
Command Modes ROUTER BGP
Command History
Version 8.2.1.0
Version 7.4.1.0
Usage
Peers that are enabled within a peer group are disabled when their peer group is disabled.
Information
The neighbor shutdown command terminates all BGP sessions on the BGP neighbor or
BGP peer group. Use this command with caution as it terminates the specified BGP sessions.
When a neighbor or peer group is shutdown, use the show ip bgp summary command to
confirm its status.
Related
Commands

neighbor subnet

Enable passive peering so that the members of the peer group are dynamic.
C-Series, E-Series
Syntax neighbor peer-group-name subnet subnet-number mask
To remove passive peering, use the no neighbor peer-group-name subnet
subnet-number mask command.
492
Enter the IPv6 address in the x:x:x:x::x format.
NOTE: The :: notation specifies successive hexadecimal fields of
zeros.
Enter the name of the peer group to disable or enable all routers
within the peer group.
Introduced on the E-Series ExaScale.
Introduced
• show ip bgp summary
• show ip bgp neighbors
– displays the current BGP configuration.
– displays the current BGP neighbors.