Ecmp-Group - Dell Force10 Z9000 Reference Manual

Usage This command applies to any physical interface with speed set to 10/100.
Information
Related
speed (for 10/100/1000 interfaces)
Commands
negotiation auto

ecmp-group

Provides a mechanism to monitor traffic distribution on a link aggregation group (LAG) bundle. A system log or simple
network management protocol (SNMP) trap is generated when the standard deviation of traffic distribution on a member
link exceeds a defined threshold.
S4810
Syntax ecmp-group {ecmp-path} [interface interface] [monitoring
enable]
To negate a command, use the no command.
Parameters
ecmp-path
interface
monitoring
Defaults Off
Command Modes CONFIGURATION
Command History
Version 8.3.10.0
NOTE: Starting with FTOS version 7.8.1.0, when you use a copper SFP2 module with
catalog number GP-SFP2-1T in the S25P model of the S-Series, you can manually set its
speed with the speed command. When you set the speed to 10 or 100 Mbps, you can also
execute the duplex command.
– enables or disables auto-negotiation on an interface.
Enter the path number for the LAG. The range is 2 to 64.
Enter the following keywords and slot/port to add the interface to the
LAG:
•
•
•
Enter the keyword monitoring to monitor the LAG. To enable
monitoring, follow by entering the keyword enable.
Introduced on the S4810.
– sets the speed on the Base-T Ethernet interface.
For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by the slot/port information.
For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port
information.
For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by the slot/port information.
695