Wanport - Dell Force10 Z9000 Reference Manual

Version 8.3.7.0
Version 8.1.1.0
Version 7.7.1.0
Version 7.6.1.0
Version 7.5.1.0
pre-Version
6.2.1.0
Usage
If an IP address or VRRP group is assigned to the interface, you cannot use the switchport
Information
command on the interface. To use the switchport command on an interface, only the no
ip address and no shutdown statements must be listed in the show config
output.
When you enter the switchport command, the interface is automatically added to the
default VLAN.
To use the switchport backup interface command on a port, you must first enter
the switchport command. For more information, refer to the "Configuring Redundant Links"
section in the "Layer 2" chapter of the
Related
interface port-channel
Commands
show interfaces switchport

wanport

Enable WAN mode on a TenGigabitEthernet interface.
E-Series
Syntax wanport
To disable the WAN Port, enter the no wanport command.
Defaults Not configured.
Command Modes CONFIGURATION
Command History
Version 8.1.1.2
pre-Version
6.2.1.0
Usage
The port must be in a shutdown state to change from LAN mode to WAN mode and vice-versa
Information
as shown in the Example below.
For E-Series ExaScale systems, you must configure all the ports in a port-pipe to either
WANPHY or non-WANPHY. They cannot be mixed on the same port-pipe.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Added the backup interface option.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
FTOS Configuration Guide .
– creates a port channel interface.
– displays information about switchport interfaces.
Introduced on the E-Series ExaScale.
Introduced on the E-Series.
751