Offline Stack-Unit - Dell Force10 Z9000 Reference Manual

level2
verbose
testname
Defaults none
Command Modes EXEC Privilege
Command History
Version 8.3.11.1
Version 8.3.1.0
Version 7.7.1.0

offline stack-unit

Place a stack unit in the offline state.
S-Series, Z-Series
Syntax offline stack-unit number
Parameters
number
Defaults none
Command Modes EXEC Privilege
Command History
Version 8.3.11.1
Version 8.2.1.0
Version 7.7.1.0
Usage
You cannot enter this command on a Master or Standby unit.
Information
The system reboots when the off-line diagnostics complete. This is an automatic process. A
warning message appears when the offline stack-unit command is implemented.
572
possible. There are no tests on 10G links. At this level, stack ports are
shut down automatically.
Enter the keyword level2 to run Level 2 diagnostics. Level 2
diagnostics are a full set of diagnostic tests with no support for
automatic partitioning. Level 2 diagnostics are used primarily for on-
board loopback tests and more extensive component diagnostics.
Various components on the board are put into Loopback mode and
test packets are transmitted through those components. These
diagnostics also perform snake tests using VLAN configurations. You
must physically remove the unit from the stack to test 10G links.
Enter the keyword verbose to run the diagnostic in Verbose mode.
Verbose mode gives more information in the output than Standard
mode.
Enter the keyword level2 to run a specific test case. Enclose the
test case name in double quotes (" "). For example: diag stack-
unit 1 level1 testname "first".
Introduced on the Z9000.
Introduced the verbose option.
Introduced on the S-Series.
Enter the stack-unit number. The range is 0 to 7.
Introduced on the Z9000.
Added a warning message to the off-line diagnostic.
Introduced on the S-Series.