Group - Dell Force10 Z9000 Reference Manual

interface configured and enabled in the Port Channel. If that first interface goes down, the Port
Channel does not change its designated speed; you must disable and re-enable the Port
Channel or change the order of the channel members configuration to change the designated
speed. If the Port Channel contains a mix of interfaces with 100 Mb/s speed and 1000 Mb/s
speed, the software disables those interfaces whose speed does not match the speed of the
first interface configured and enabled in the Port Channel. If that first interface goes down, the
Port Channel does not change its designated speed; you must disable and re-enable the Port
Channel or change the order of the channel members configuration to change the designated
speed. For more information about Port Channels, refer to the
Related
description
Commands
interface port-channel
shutdown

group

Group two LAGs in a supergroup ("fate-sharing group" or "failover group").
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax group group_number port-channel number port-channel number
To remove an existing LAG supergroup, use the no group group_number command.
Parameters
group_number
port-channel
number
Defaults none
Command Modes PORT-CHANNEL FAILOVER-GROUP (conf-po-failover-grp)
Command History
Version 8.3.11.1
Version 8.3.7.0
Version 8.1.1.0
Version 7.6.1.0
Related
port-channel failover-group
Commands
a LAG failover group.
show interfaces port-channel
754
– assigns a descriptive text string to the interface.
– creates a Port Channel interface.
– disables/enables the port channel.
Enter an integer from 1 to 32 that uniquely identifies this LAG fate-
sharing group.
Enter the keywords port-channel followed by an existing LAG
number. Enter this keyword/variable combination twice, identifying
the two LAGs to be paired.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Introduced on the C-Series, E-Series, and S-Series.
– accesses PORT-CHANNEL FAILOVER-GROUP mode to configure
– displays information on configured Port Channel groups.
FTOS Configuration Guide .