show ip cam stack-unit
Display CAM entries for an S-Series or Z-Series switch.
S-Series, Z-Series
Syntax
show ip cam stack-unit id port-set pipe-number [ip-address mask
[longer-prefixes] | summary]
Parameters
id
pipe-number
ip-address mask
[longer-prefix]
summary
Command Modes
Command History
Version 8.3.11.1
Version 7.7.1.0
Version 7.6.1.0
Usage
The following describes the show ip cam command shown in the Example below.
Information
Field
Destination
EC
CG
V
C
V Id
Mac Addr
Enter the stack-unit ID.
The unit ID range is 0 to 7 for S-Series.
Enter the number of the Port-Pipe number. The S50n and S50V range
is 0 to 1. The S25N, S25P, and S25V range is 0 to 0.
(OPTIONAL) Enter the IP address and mask of a route to CAM entries
for that route only. Enter the keywords longer-prefixes to view
routes with a common prefix.
(OPTIONAL) Enter the keyword summary to view a table listing route
prefixes and the total number routes which can be entered in to CAM.
•
EXEC
•
EXEC Privilege
Introduced on the Z9000.
Added support for up to seven stack members.
Introduced on the S-Series.
Description
Displays the destination route of the index.
Displays the number of equal cost multipaths (ECMP) available for
the default route for non-Jumbo line cards. For Jumbo line cards,
displays 0,1 when ECMP is more than eight.
Displays 0.
Displays a 1 if the entry is valid and a 0 otherwise.
Displays the CPU bit. 1 indicates that a packet hitting this entry is
forwarded to the CP or RP2, depending on Egress port.
Displays the VLAN ID. If the entry is 0, the entry is not part of a VLAN.
Displays the next-hop router's MAC address.
811